–
| Tighten cylinder head bolts in tightening sequence as follows: |
–
| First tighten all bolts to 40 Nm. |
–
| Then retighten all bolts 1/4 turn (90°) further using a rigid wrench. |
–
| Then retighten all bolts again 1/4 turn (90°). |
Note It is not necessary to retighten cylinder head bolts after repairs. |
–
| Replace the turbocharger/exhaust manifold gasket, and firmly screw the turbocharger, together with its mounting, to the cylinder block. |
Installing timing belt and adjusting valve timing → Chapter. |
Continue installation following reverse order for removing. |
|
|
|