SEAT Workshop Service and Repair Manuals

Air duct with coolant fan -V7- and coolant fan 2 -V177-: Removing and installing

Removal: –  Loosen the engine cover at the locations -arrows- and remove.

–  Open intake system cover by carefully releasing fasteners -arrows-.

–  Remove securing bolts -arrows- for intake system -1- and take connecting hose -2- out of guide.

–  Remove upper securing bolts -upper arrows- of cowling. –  Remove the soundproofing or the underbody protection → Bodywork, exterior assembly work; Rep. gr.50. –  Disconnect connector -1- and free wiring.

–  Remove connecting hose on »hot side« from charge air pipe. To do this, detach hose clips -1-.

–  Remove connecting hose on »cold side« from charge air pipe. To do this, loosen hose clips.

–  Unscrew lower bolts -lower arrows-. –  Remove cowling together with radiator fans downwards.

Vehicles with 2 radiator fans –  Disconnect electrical connector -1- and free electrical wiring. –  Remove the nuts -arrows- and remove the radiator fan.

Vehicles with one radiator fan –  Unscrew bolts -arrows- and remove radiator fan. Specified torque -arrows- 6 Nm Installation Installation is in the reverse sequence of removal.