SEAT Workshop Service and Repair Manuals

A - Mount the seal along with the sender wheel on the assembly tool -T10134- –  Screw in hexagon nut -B- to just before clamping surface -A- of threaded spindle.

–  Fix the fitting device -T10134- holding it in place in a bench vice, to the threaded spindle surface -B-. –  Press down on the installation bell -C-, so that it rests -arrow- on the hexagonal bolt -B-.   Note Inner part of assembly device and assembly housing must align (be level) with each other.

–  Unscrew the attachment clip -arrow- from the new sealing flange.   Note The sender wheel must not be taken out of the sealing flange or rotated out of position.

l  Locating hole -A- on sender wheel -C- must align with marking -B- on sealing flange. –  Place sealing flange with front side downwards on a clean flat surface.

–  Press the sealing lip pressure ring -A- in the -direction of the arrow- downwards until it rests on the flat surface.

l  The upper edge of the sender wheel and the front edge of the sealing flange must align -arrows-.

–  Place the front of the sealing flange on the fitting device -T10134-, so that the fastener -B- sits into the hole -A- in the sender wheel.   Note Ensure that the sealing flange presses completely on the fitting device.

–  Tighten the sealing flange and the sealing lip pressure ring -B- while tightening the three knurled bolts -A- on the surface of the fitting device -T10134- so that the fastener cannot come out of the hole in the sender wheel.   Note When installing sealing flange, ensure that sender wheel remains fixed in assembly device.