SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4-cylinder diesel engine (1.6 l 4V, TDI Common-Rail) | Enginecrankshaft group, pistons | Removing and installing sealing flange and flywheel | Sealing flange (gearbox side): replace | D - Press the sender wheel with the centre guideT10134 onto the crankshaft flange:

D - Press the sender wheel with the centre guideT10134 onto the crankshaft flange:

D - Press the sender wheel with the centre guide -T10134- onto the crankshaft flange:

–	Tighten the hexagon nut of the fitting device -T10134- using the torque wrench -VAG 1331- and the insert e/c 24 terminal -VAG 1332/11- to 35 Nm.

Note

A small air gap must be present between cylinder block and sealing flange after tightening hexagon nut to 35 Nm.