seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Checking exhaust system for leaks > < Exhaust system: install without stress

Leon Mk2

Installation position and specified torque of clamp
Installation position and specified torque of clamp
  Note
Gradual introduction of clamp with continuous clip.
   
Specified torque and installation dimensions of clamp
Clamp -A- with 2 individual clips.
   Tightening torque: 25 Nm
   Installation dimensions -a- 5 mm (only for front clamp)
Clamp -B- with continuous clip.
   Tightening torque: 35 Nm
   Installation dimensions -a- 8.5 mm (only for front clamp)
  N26-10627
Installation dimension -a- for vehicles with marking on front exhaust pipe
1 - Attachment bush
2 - Primary exhaust pipe
a - Installation dimension
A - Brand
  N26-10302
Installation position of front clamp
–  Install clamp so that end of bolt -arrow- does not extend beyond lower edge of clamp.
l  Threaded connection faces right.
  N26-0468
Installation position of rear clamp
–  Install clamp so that end of bolt -arrow- does not extend beyond lower edge of clamp.
l  Threaded connection faces to rear.
  N26-0468

Checking exhaust system for leaks > < Exhaust system: install without stress