SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4-cylinder diesel engine (1.6 l 4V, TDI Common-Rail) | Exhaust system | Exhaust system (Ibiza) | Particle filter Removing and installing

Installation

Installation is carried out in reverse order, noting the following:

Note

t	Before installing subframe with steering box ensure that seal on steering box contacts the assembly plate without kinks. Ensure opening to footwell is correctly sealed. Otherwise water could leak in and/or there will be more noise.

t	Replace the seals, self-locking nuts and particulate filter clamps.

t	When fitting, attach all cable ties back to the same location.

Check fitting position of seal -arrow- (steering donut).

Install in reverse order of removal; note the following:

–	Renew gasket/seals → Item.

Observe sequence when installing particulate filter:

Position particulate filter on turbocharger and secure clip -1- loosely

screw bolts and nuts -2 … 5- in by hand

l	Particulate filter and retainer must be able to move

Tighten clip -1-

Tighten nuts and bolts -2- and -5-

Tighten nuts and bolts -3- and -4-

Tightening torque of the heat protection plate bolts, drive shaft -1-: 35 Nm.

–	Align exhaust system without tension → Chapter

When replacing the particulate filter

–	After replacing front exhaust pipe, perform adaptation in operating mode „Guided functions“ → Vehicle diagnostic tester.

SEAT Workshop Service and Repair Manuals