seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Ignition system, glow plug system > < Removing and installing exhaust gas recirculation system
Exhaust gas recirculation radiator switching valve: check
Exhaust gas recirculation radiator switching valve: check
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Manual vacuum pump -VAS 6213-, see equivalency → Anchor
  W00-10259
Procedure
–  Remove heat shield sleeve.
–  Remove the vacuum hose from the vacuum socket and connect the Manual vacuum pump -VAS 6213- in its place.
–  Operate hand vacuum pump to create a vacuum.
l  The linkage of the exhaust gas recirculation cooler changeover must move -arrows-.
If linkage does not move or only moves in jerks:
t  Vacuum actuator is defective.
t  Changeover flap for exhaust gas recirculation is tight.
  Note
When fitting the heat protection plate, fit to the same location.
  A26-10878

Ignition system, glow plug system > < Removing and installing exhaust gas recirculation system