seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing intake manifold > < Assembly overview - intake manifold with attachments

Leon Mk2

Removing and installing throttle valve moduleJ338
Removing and installing throttle valve module -J338-
t  Removing → Anchor
t  Fitting → Anchor
   
Removing
–  Loosen the engine cover at the locations -arrows- and remove.
  E10-10087
–  Unscrew the securing bolts -arrows- and remove the engine soundproofing..
  E10-0086
–  Loosen the angled bracket -arrow- and remove the right hose from the charged air cooler.
  N19-10342
–  Remove bolts -arrows-.
–  Free coolant hose -3-.
–  Release the hose clamp -2-.
–  Unplug electrical connector -1- at charge air pressure sender -G31-/charge air pressure sender -G42- and remove the right air intake pipe.
  A21-10435
–  Disconnect electrical connector -2-.
–  Remove bolt -1- for dipstick guide tube.
–  Unscrew the bolts -arrow- and remove the throttle valve control unit -J338-.
Fitting
Installation is carried out in the reverse order; note the following:
l  Specified torque → Chapter „Assembly overview - intake manifold with attachments“.
  Note
Renew O-ring.
–  Install air pipe at the front → Chapter.
–  Fit the centre sound proofing → Exterior body installation work; Rep. gr.50 .
  A23-10448

Removing and installing intake manifold > < Assembly overview - intake manifold with attachments