SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Lower coolant pipe: Removing and installing >
< Coolant pump: Removing and installing
Leon Mk2
Power unit
4-cylinder engine (2-valve), mechanical stage
Engine cooling / Removing and installing parts of cooling system
Upper coolant pipe: Removing and installing
Upper coolant pipe: Removing and installing
Upper coolant pipe: Removing and installing
t
Removing
→ Anchor
t
Installing
→ Anchor
t
Tightening torques
→ Anchor
Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda
→ Chapter
Special tools and workshop equipment required
t
Pliers for spring-loaded band-type clamps -VAS 6499-, see equivalent
→ Anchor
t
Torque wrench -VAG 1331-, see equivalent
→ Anchor
.
Removing
–
Drain coolant
→ Chapter
.
–
Detach vent hose
-2-
leading to exhaust gas recirculation valve -N18-.
–
Disconnect the hose
-4-
from the crankshaft sump breather on the air duct.
–
Remove air pipe
-1-
and
-3-
.
–
Move wiring at coolant pipe (top) clear.
–
Unscrew bolts
-1-
and
-2-
and detach top coolant pipe from coolant hoses
-arrows-
.
Installing
Reassembly is carried out in the reverse order; note the following:
Note
Secure all screw joints with serial hose clips
→ Spare parts catalogue
.
–
Fill up with coolant
→ Chapter
.
Tightening torques
Components:
Nm
Coolant pipe (top) to intake manifold
10
Power unit
4-cylinder engine (2-valve), mechanical stage
Engine cooling / Removing and installing parts of cooling system
Upper coolant pipe: Removing and installing
Lower coolant pipe: Removing and installing >
< Coolant pump: Removing and installing