SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing coolant pipe (bottom) >
< the lower coolant pipe: Removing and installing
Leon Mk2
Power unit
4-cylinder engine (2.0l 4V, TDI Common Rail)
Engine cooling / Parts of the cooling system (motor-side)
Removing and installing coolant pipe (rear)
Removing and installing coolant pipe (rear)
Removing and installing coolant pipe (rear)
t
Removing
→ Anchor
t
Installing
→ Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda
→ Chapter
.
Special tools and workshop equipment required
t
Pliers for spring-loaded band-type clamps -VAS 6499-, see equivalent
→ Anchor
Removing
–
Disconnect the engine cover
-arrow-
.
–
Remove coolant pipe (top)
→ Chapter
.
–
Unscrew nuts
-arrows-
and place bearing with fuel filter and hoses
-1-
and
-2-
connected down to side.
–
Pull out the plug
-2-
.
–
Remove the coolant hose. Loosen the hose clips
-1-
and
-3-
for this purpose.
–
Unscrew nuts
-arrows-
and pull out coolant hose.
Installing
Installation is carried out in the reverse sequence; note the following:
l
Tightening torques
→ Chapter „Coolant lines, coolant temperature senders, coolant circulation pump: Assembly overview“
–
Install fuel filter
→ Chapter
.
Power unit
4-cylinder engine (2.0l 4V, TDI Common Rail)
Engine cooling / Parts of the cooling system (motor-side)
Removing and installing coolant pipe (rear)
Removing and installing coolant pipe (bottom) >
< the lower coolant pipe: Removing and installing