seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Fuel tank and accessory parts - general component overview > < Removing and installing fuel cooler

Leon Mk2

Fuel supply, vehicles with four-wheel drive
Fuel supply, vehicles with four-wheel drive
t  → Chapter „Fuel tank and accessory parts - general component overview“.
t  → Chapter „Removing and installing fuel tank with attached components“.
t  → Chapter „Fuel supply unit and fuel level indicator sender: component overview“.
t  → Chapter „Fuel pump control unit -G6-, check the electric function“.
t  → Chapter „Removing and installing fuel delivery unit“.
t  → Chapter „Checking fuel gauge sender -G-“.
t  → Chapter „Removing and installing fuel gauge sender -G-“.
t  → Chapter „Checking fuel gauge sender 2 -G169-“.
t  → Chapter „Removing and installing fuel gauge sender 2 -G169-“.
t  → Chapter „Spray jet:“.
t  → Chapter „Removing and installing suction-jet pump“.
  Note
t  Secure all screw joints with serial hose clips → Parts catalogue.
t  Always replace the O-rings and the gaskets during fitting work.
  WARNING
t  The fuel system is pressurised. Before opening the system place a cloth around the connection. Then release pressure by carefully loosening the connection.
t  The temperature of the fuel lines or the fuel may reach up to 100 ºC in extreme cases. Before opening the duct connections, allow the fuel to cool otherwise there is a risk of severe burns.
t  Wear protective gloves.
t  Wear eye protection.
   

Fuel tank and accessory parts - general component overview > < Removing and installing fuel cooler