SEAT Workshop Service and Repair Manuals

Removing and installing charge air cooler t  Removing → Anchor. t  Installing → Anchor.   Note Check all hoses and pipes for correct fitting and leakage before carrying out tests or repairs.

Removing –  Release quick-fasteners -1- and -2- and take off front noise insulation. –  Remove the front bumper cover → exterior body installation work; Rep. gr.63. –  Remove headlights (left/right) → Electrical system; Rep. gr.94.

Only the charge air cooler on left side –  Remove the air duct in front of the left charge air cooler -arrows-.

–  Detach electrical connector -3- at charge air pressure sender -G31-.   WARNING The air conditioning refrigerant circuit must not be opened. –  Hook the bracket -4- on the coolant line of the AC system. –  Open hose clips -1- and -2- and disconnect air intake hoses. –  Detach charge air cooler by pulling upwards.

Only the charge air cooler on the right side –  Remove air duct in front of charge air cooler (right-side) -arrow-.

–  Release the hose clips -arrows- and pull out the air guiding hoses. –  Detach charge air cooler by pulling upwards. Installing Reassembly is carried out in the reverse order; note the following:   Note t  Hose connections and hoses for charge air system must be free from oil and grease before fitting. t  Secure all screw joints with serial hose clips → Spare parts catalogue. –  Install headlight → Electrical system; Rep. gr.94 –  Fit the front bumper cover → Exterior body installation work; Rep. gr.63. –  Check headlight adjustment → Booklet301. Specified torque .

Components:	Nm
Hose clips (13 mm wide)	5,5