SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4-Cylinder injection engine (1.4 l engine with direct injection engine, turbocharger and displacement compressor) | Enginecrankshaft group, pistons | Removing and installing sealing flange and flywheel/drive plate | Removing and installing engine speed senderG28

Removing and installing engine speed senderG28

Removing and installing engine speed sender -G28-

The engine speed sender -G28- is located on the sealing flange on the flywheel end of the crankcase.

Special tools and workshop equipment required

t	Hose clip pliers -VAS 6340-

t	Torque wrenches -V.A.G 1331-

t	Guide pins -T10341-

t	Locking pin -T10060 A-

t	Special wrench -T10370-

Removing

–	Remove toothed belt → Chapter

–	Pull off connector -1- from engine speed sender -G28-.

–	Remove gasket -2- from cylinder block and remove engine speed sender -G28- with socket -T10370-.

Fitting

–	Install engine speed sender -G28- and tighten securing bolt to 5 Nm.

Further assembly is basically the reverse of the dismantling sequence.

SEAT Workshop Service and Repair Manuals