seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Exhaust manifold: stripping and fitting > < Silencer with mountings: stripping and fitting

Leon Mk2

Exhaust system: positioning
Exhaust system: positioning
Prerequisites
l  Engine must be cold.
Procedure
–  Loosen the screw joint of the double clamp between the catalytic converter and the intermediate silencer and replace the nuts.
   
–  Place the double clamp at a distance -a- = 5 mm from the mark on the catalytic converter pipe (lower bolts in horizontal position) and tighten slightly the front joint.
  E26-0059
–  Fit the pre-silencer -1- into the double clamp to level -b- of 3 … 7 mm between suspension/bodywork and suspension/pre-silencer (the arrow indicates the running direction).
–  In this position, tighten the double clamp bolts uniformly to 40 Nm.
–  After tightening the double clamp, check the dimension -b- and ensure it is correct.
–  Position the post-silencer horizontally.
  E26-0060

Exhaust manifold: stripping and fitting > < Silencer with mountings: stripping and fitting