Leon Mk2
| Intake manifold: disassembly and assembly |
| 1 - | Throttle valve control unit -J338- |
| q | After replacing, adapt the engine control unit → Chapter, Adapting functions and components |
| 2 - | 10 Nm |
| 3 - | Gasket |
| q | Check the fitting position |
| q | Replace |
| 4 - | Intake hole |
| 5 - | Seal |
| q | Replace if worn |
| 6 - | 20 Nm |
| 7 - | Seal |
| q | Replace |
| 8 - | Guide plate |
| q | Check the fitting position |
| q | Replace if worn |
| 9 - | O-ring |
| q | Replace if worn |
| 10 - | 3 Nm |
| 11 - | Intake manifold pressure sender -G71- with intake air temperature sender -G42- |
| q | Resistance values for intake air temperature sender between contacts 1 and 2 → Fig. |
| 12 - | Intake manifold |
| q | Remove and fit → Chapter |
| 13 - | Vacuum hose |
| q | Comes from the fuel pressure regulator → Item |
