seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Fuel supply, gas operation > < Coolant pump: Removing and installing

Leon Mk2

Remove
Remove
–  Remove the engine and air filter guard → Chapter, Engine: removing and installing.
–  Remove the Poly-V belt → Chapter.
–  Bleed the coolant liquid → Chapter.
–  Remove the clamp that fastens the flexible coolant hose to the coolant pump.
–  Remove the Lambda probe's connector and withdraw the support.
–  Separate the front exhaust pipe from its connection to the exhaust manifold.
   
–  Remove the screws -arrows- that secure the front coolant hose.
  N19-0229
–  Fit fastening cross-member -U-30025- as shown, secure the -U-30025-'s tensioner on the support next to the distribution -arrow-.
  E19-0019
–  Remove the securing screws from the engine unit's front support -arrows-.
–  Remove the coolant pump pulley. To do so, it is necessary to lift the engine unit slightly by working the -U-30025-'s tensioner.
–  Remove the pulley's securing bolts (block by inserting a punch in one of the holes on the pulley).
–  Withdraw the coolant pump's securing nuts and bolts and remove the pump.
  Note!
t  In order to remove or install the coolant pump, lift the engine unit slightly using special tool -U-30025-, and slightly press towards the rear.
t  When fitting the coolant pump, make sure that the gasket is not damaged.
Install
Carry out assembly in reverse order and observe the following:
–  Renew the coolant pump gasket.
–  Tighten the coolant pump's securing bolts/nuts to a torque of 20 Nm.
–  Tighten the belt pulley's securing bolts to a torque of 10 Nm.
–  Tighten the engine unit's securing bolts → Anchor, Tightening torques.
–  Tighten the securing bolts on the coolant hose to a torque of 20 Nm.
–  Fit the Poly-V belt → Chapter.
–  Fill coolant liquid → Chapter.
  N19-0211

Fuel supply, gas operation > < Coolant pump: Removing and installing