Leon Mk2
| Part I; Notched belt mechanism - Components overview |
| 1 - | Notched belt guard - upper part |
| 2 - | 20 Nm + 1/4 turn (90°) |
| q | Renew |
| q | Use locking spanner -T10016- → Fig.to loosen and tighten |
| 3 - | Camshaft gear |
| q | Note the position when fitting the toothed belt → Chapter |
| 4 - | Tension roller of the derived branch of the notched belt. |
| q | Testing → Chapter |
| q | Tension the notched belt. → Chapter |
| 5 - | Secondary branch notched belt |
| q | Mark D.O.R. before removing |
| q | Check for wear |
| q | Do not kink |
| q | Removing, installing and tensioning → Chapter |
| 6 - | Support |
| q | The engine, identification letters BXW, is not fitted with this |
| 7 - | 10 Nm |
| 8 - | Front of coolant pump |
| q | If damaged or leaking: replace completely |
| q | Removing and installing → Chapter |
| 9 - | Rear notched belt guard |
| 10 - | 20 Nm |
| 11 - | 50 Nm |
| 12 - | Idler roller for principal notched belt |
| 13 - | Principal notched belt tension roller |
| q | Testing → Chapter |
| q | Notched belt: fitting and tensioning → Chapter |
| 14 - | Crankshaft toothed belt wheel |
| q | Observe position when fitting the toothed belt → Chapter |
| 15 - | Principal notched belt: |
| q | Mark D.O.R. before removing |
| q | Check for wear |
| q | Do not kink |
| q | Notched belt routing → Fig. |
| q | Removing, installing and tensioning → Chapter |
| 16 - | 12 Nm |
| q | Renew |
| 17 - | Pulley |
| q | Note location when installing |
| q | Removing and installing → Chapter; Notched belt: removing, installing and tensioning |
| 18 - | 90 Nm + 1/4 turn (90°) |
| q | Renew |
| q | Lubricate before fitting |
| q | Tightening can be done in several stages |
| q | The tightening angle may be measured with a protractor, for example measuring tool -T20030- |
| 19 - | Poly-V belt |
| q | Mark direction of rotation before removing |
| q | Removing and installing → Chapter |
| q | Poly-V belt routing → Anchor |
| q | Vehicles fitted with air conditioning (heating) have an additional idler roller |
| 20 - | Notched belt guard - lower part |
| 21 - | Engine mounting |
| 22 - | 50 Nm |
| q | Renew |
| 23 - | 25 Nm |
| q | The engine, identification letters BXW, is not fitted with this |
| 24 - | Idle wheel |
| q | The engine, identification letters BXW, is not fitted with this |
