| Measuring radial clearance of crankshaft |
| Special tools and workshop equipment required |
| –
| Remove bearing cap and clean bearing journal. |
| –
| Place a length of Plastigage corresponding to the width of the bearing on the journal or into the bearing shells. |
| l
| The Plastigage must be positioned in the centre of the bearing shell. |
| –
| Fit bearing cap and tighten to 65 Nm. Do not turn crankshaft. |
| –
| Remove bearing cap again. |
| –
| Compare width of Plastigage with measurement scale. |
|
|
|
