SEAT Workshop Service and Repair Manuals

Removing and installing poly V-belt t  Removing → Anchor t  Fitting → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Spanner -T20126-, see equivalent → Anchor

t  Adjustment tool -T40098-, please see Correspondence → Anchor

Removing –  Remove engine cover panel -arrows-.

–  Loosen quick-type locks -1 and 2- and remove front noise insulation.

–  Open clips -arrows- and remove toothed belt cover.

–  Move tensioning element with wrench -T20126- clockwise -arrow-, remove poly-V-belt from generator pulley, align openings and arrest tensioning element with aid of adjustment tool -T40098-.   Note

Place the holes -arrows- above each other and lock the clamping element using the retention tool -T40098-.   Caution Risk of breakage if the poly V-belt runs in the opposite direction when refitted. Before removing, mark direction of rotation of toothed belt with chalk or felt-tip pen for re-installation. –  Remove poly V-belt. Installing Reassembly is carried out in the reverse order; note the following:

–  Fit poly V-belt on poly V-belt pulley: 1 -  Alternator 2 -  Idler roller 3 -  Power steering pump 4 -  Air conditioning compressor 5 -  Poly V-belt tensioning element 6 -  Vibration damper   Note When installing poly V-belt, make sure it is properly seated on pulleys. –  Start engine and check that belt runs properly.