Leon Mk2
| Parts of cooling system, engine side |
| 1 - | 15 Nm |
| 2 - | Coolant pump |
| q | Check for ease of movement |
| q | Note fitting position: |
| q | removing and fitting → Chapter |
| 3 - | O ring |
| q | Replace |
| 4 - | To top of expansion tank |
| q | Coolant hose schematic diagram → Chapter |
| 5 - | Upper metal tube for coolant |
| q | Screwed onto cylinder head cover |
| q | Coolant hose schematic diagram → Chapter |
| 6 - | To exhaust gas recirculation cooler. |
| 7 - | Joint mouth |
| q | For the heat exchanger |
| 8 - | Coupling hose |
| 9 - | Coolant temperature sender |
| 10 - | Retaining clip |
| q | Check for secure seating. |
| 11 - | O ring |
| q | Replace |
| 12 - | From the exhaust gas recirculation cooler |
| 13 - | Joint mouth |
| 14 - | 10 Nm |
| q | 2 off |
| 15 - | Coolant hose |
| 16 - | 40 Nm |
| 17 - | To the upper section of the radiator |
| q | Coolant hose schematic diagram → Chapter |
| 18 - | Distribution element |
| 19 - | Metal pipe for Coolant |
| q | Coolant hose schematic diagram → Chapter |
| 20 - | To bottom of expansion tank |
| q | Coolant hose schematic diagram → Chapter |
| 21 - | To the lower section of the radiator |
| q | Coolant hose schematic diagram → Chapter |
| 22 - | Joint mouth |
| q | For thermostat |
| 23 - | Coolant thermostat: |
| q | removing and fitting → Chapter |
| q | Note installation position → Chapter |
| q | Check: heat the thermostat in water |
| q | Starts opening at approx. 85 ℃ |
| q | Ends at approx. 105 °C. |
| q | Minimum opening distance 7 mm |
| 24 - | Oil cooler |
| q | removing and fitting → Item |
