Leon Mk2
| Cylinder head cover: Assembly overview |
| 1 - | Gasket |
| q | Renew if damaged or leaking. |
| 2 - | Cylinder head cover |
| q | Removing and installing → Chapter |
| 3 - | O ring |
| q | Renewing |
| 4 - | Hose |
| q | For engine block ventilation pre-heater |
| q | To remove, press the release tags. |
| 5 - | Sealing bushing |
| q | For fuel rail |
| q | Renew if damaged or leaking. |
| 6 - | Retainer |
| q | For the electric wiring |
| 7 - | Grommet |
| 8 - | Clamping piece |
| 9 - | 8 Nm |
| 10 - | High-pressure accumulator (fuel rail) |
| q | Observe rules for cleanliness → Chapter. |
| q | Do not attempt to reshape high-pressure lines. |
| q | Install the high-pressure pipes → Chapter |
| 11 - | 22 Nm |
| 12 - | 8 Nm + turn 180° further |
| q | Renewing |
| 13 - | Fuel return line |
| 14 - | O ring |
| q | Renewing |
| 15 - | Injector |
| q | Observe rules for cleanliness → Chapter. |
| q | Removing and installing → Chapter |
| 16 - | O ring |
| q | Renewing |
| 17 - | Heat proof joint |
| q | Renewing |
| 18 - | Oil seal |
| q | For injectors |
| q | Renew → Chapter |
| 19 - | Cap |
| 20 - | Gasket |
| q | For cap. |
| 21 - | Grommet |
| 22 - | Retainer |
| q | For the electric wiring |
| 23 - | Bolt |
| q | Replace if seal damaged |
| q | Specified torques and installation sequence → Fig.. |
|
|
