Leon Mk2
| Assembly overview - toothed belt drive |
| 1 - | Toothed belt |
| q | Mark direction of rotation before removing. |
| q | Check for wear. |
| q | Do not kink. |
| q | removing, fitting, tensioning |
| 2 - | 120 Nm + turn 90° further |
| q | Renew |
| q | Use counterhold tool -3415- to loosen and tighten. |
| q | Do not additionally oil or grease the threads and shoulder. |
| q | Turning further can be done in several stages. |
| 3 - | Crankshaft toothed belt pulley |
| 4 - | 20 Nm |
| 5 - | Guide roller |
| 6 - | 20 Nm + turn 45° further |
| 7 - | Tensioning roller |
| q | Remove engine bracket in order to remove and install → Chapter |
| 8 - | 20 Nm + turn 45° further |
| 9 - | Camshaft pulley |
| 10 - | 20 Nm |
| 11 - | 100 Nm |
| 12 - | Hub |
| q | Use counterhold tool -T10051- to loosen and tighten. |
| q | To remove, use puller -T10052-. |
| q | Removing and installing → Chapter |
| 13 - | Rear toothed belt guard |
| 14 - | 20 Nm |
| 15 - | 10 Nm |
| q | Renew |
| 16 - | Guide roller |
| 17 - | 50 Nm + turn 90° further |
| q | Renew |
| 18 - | Hub |
| q | Use counterhold tool -T10051- to loosen and tighten. |
| q | To remove, use puller -T40064-. |
| q | Removing and installing. |
| 19 - | 95 Nm |
| 20 - | Toothed belt pulley on high-pressure pump |
| 21 - | 20 Nm |
| q | Renew |
| 22 - | Coolant pump |
| q | Removing and installing → Chapter |
| 23 - | 15 Nm |
| 24 - | Toothed belt guard upper part |
| 25 - | Lower toothed belt guard |
| 26 - | Toothed belt guard centre part |
| 27 - | 10 Nm |
| q | Renew |
| 28 - | 10 Nm + turn 90° further |
| q | Renew |
| 29 - | Belt pulley and vibration damper |
| q | Assembly through offset holes only possible in one position. |
| 30 - | 5 Nm |
| 31 - | Protective plate |
| 32 - | 40 Nm + turn 180° further |
| q | Renew |
| q | Observe tightening sequence → Chapter. |
| 33 - | Engine bracket |
| q | Removing and installing → Chapter. |
