Leon Mk2
|
| 1 - | Oil pan |
| q | Removing and installing → Chapter |
| q | Mount with sealant mass; sealant mass → spare parts catalogue |
| 2 - | Torque reaction support |
| 3 - | 23 Nm |
| 4 - | Oil pump: |
| q | With 12 bar pressure relief valve |
| q | Removing and installing → Chapter |
| q | Before installing, check that the two dowel sleeves → Item for centring oil pump/cylinder block are fitted. |
| q | Replace if there is scoring on the friction surfaces or the gear teeth. |
| q | Tightening torque of the oil pump cover at the oil pump housing: 10 Nm 10 Nm |
| 5 - | Oil-pump chain sprocket |
| q | Sprocket can only be fitted on oil pump shaft in one position. |
| 6 - | 22 Nm |
| 7 - | Drive chain for oil pump |
| q | Mark direction of rotation before removing. |
| q | Check for wear |
| 8 - | 15 Nm |
| 9 - | Front sealing flange: |
| q | Must sit on dowel sleeves |
| q | Removing and installing → Chapter |
| q | Mount with sealant mass; sealant mass → spare parts catalogue |
| q | Replace the sealant ring (gasket) for crankshaft on the V-belt side → Chapter |
| 10 - | Chain tensioner |
| q | Tighten to 16 Nm |
| q | Do not dismantle |
| q | Note fitting position: |
| q | Pre-tension spring and engage before installing |
| q | If the spring is broken, renew chain tensioner as complete unit |
| 11 - | Oil-pump chain sprocket |
| q | Removing and installing → Chapter |
| 12 - | Dowel sleeves |
| q | 2 off |
| 13 - | O ring |
| q | replace |
| 14 - | 16 Nm |
| 15 - | Oil intake pipe |
| q | Clean strainer if dirty |
| 16 - | Anti-surge valve |
| 17 - | 16 Nm |
| 18 - | 15 Nm |
| q | Tighten in stages and in diagonal sequence |
| q | Observe tightening sequence → Anchor. |
| 19 - | 40 Nm |
| 20 - | Seal |
| q | replace |
| 21 - | 30 Nm |
| 22 - | Seal |
| q | replace |
| 23 - | Oil return pipe |
| q | From turbocharger |
| 24 - | 10 Nm |
|
|
