SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4 cylinder engine 1.8 litre, 2.0 litre 4V Turbo with petrol direct injection | Engine cooling | Parts of cooling system (on engine) | Removing and installing continued coolant circulation pumpV51

Removing and installing continued coolant circulation pumpV51

Removing and installing continued coolant circulation pump -V51-

t	Removing → Anchor

t	Installing → Anchor

Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter

Special tools and workshop equipment required

t	Hose clamp -3094-, see equivalent → Anchor

t	Pliers for spring-loaded band-type clamps -VAS 6499-, see equivalent → Anchor

Removing

–	Remove charge air hose (left-side) -2-.

Note

Item -1- can be disregarded.

Note

Place a cloth under coolant pipe to catch escaping coolant.

–	Clamp off coolant hoses -arrows- with hose clamps -3094- and detach.

–	Pull out the plug -2-.

–	Unscrew the bolt -1- and remove the coolant pump -V51-.

Installing

Installation is carried out in the reverse sequence; note the following:

Note

t	Hose connections and air pipes and hoses must be free from oil and grease before fitting.

t	Secure hose unions with hose clamps the same as those of the series → Electronic parts catalogue.

t	To ensure that the air hoses can be properly secured at their connections, spray rust remover onto the worm thread of used hose clips before installing.

–	Check coolant level → Anchor.

SEAT Workshop Service and Repair Manuals