SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4 cylinder engine 1.8 litre, 2.0 litre 4V Turbo with petrol direct injection | Engine cooling | Parts of cooling system (on engine) | Removing and installing coolant pipe (front)

Removing and installing coolant pipe (front)

t	Removing → Anchor

t	Installing → Anchor

Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter

Special tools and workshop equipment required

t	Hose clamp -3094-, see equivalent → Anchor

t	Pliers for spring-loaded band-type clamps -VAS 6499-, see equivalent → Anchor

Removing

Note

Place a cloth under coolant pipe to catch escaping coolant.

–	Unscrew bolts -1- and -2- and swivel coolant pipe (front) upwards.

–	Clamp off coolant hoses -arrows- with hose clamps -3094- and detach.

Installing

l	Tightening torque → Chapter

Installation is carried out in the reverse sequence; note the following:

Note

Secure hose unions with hose clamps the same as those of the series → Electronic parts catalogue.

–	Check coolant level → Anchor.

SEAT Workshop Service and Repair Manuals