seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing sump (bottom section) > < Sump, oil pump - exploded view

Leon Mk2

Removing and installing coarse oil separator
Removing and installing coarse oil separator
t  Removing → Anchor
t  Installing → Anchor
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Socket -10 222A-, see equivalent → Anchor
Removing
–  Support engine → Chapter.
  W00-0225
–  Unplug electrical connector from charge air pressure sender -G31--1-.
–  Remove charge air hose (left-side) -2-.
–  Remove front left wheel.
  A10-10320
–  Loosen the fasteners -2-, -3- and -5- and remove the front noise insulation.
–  Remove left wheel housing liner → Rep. gr.66.
–  Remove engine support (left-side).
  A10-1307
–  Remove the coarse oil separator -1 ... 9-.
Installing
Installation is carried out in the reverse sequence; note the following:
–  Coarse oil separator: Tightening sequence and torque → Fig.
l  Tightening torques: → Chapter „Assembly mountings - exploded view“
  A17-10423

Removing and installing sump (bottom section) > < Sump, oil pump - exploded view