Leon Mk2
|
| 1 - | 10 Nm |
| 2 - | Oil intake pipe |
| 3 - | aluminium cylinder block! |
| 4 - | Knock sensor |
| 5 - | 20 Nm |
| q | The torque setting influences the function of the knock sensor. |
| 6 - | 60 Nm + retighten 1/4 turn (90º) |
| q | Replace. |
| 7 - | Flywheel |
| q | To remove and fit the engine flywheel, immobilise it with the retention tool -T20176- |
| 8 - | Intermediate plate |
| q | Must sit on dowel sleeves |
| q | Do not damage/bend when assembling |
| 9 - | 12 Nm |
| q | Replace. |
| 10 - | Sealing flange with sender crown and seal |
| q | With Engine speed sender -G28- (without diagram) |
| q | Tightening torque for the engine speed sender -G28-: 5 Nm |
| q | Always replace the sealing flange together with the seal and the sender crown |
| q | Removing and fitting the sealing flange → Chapter |
| 11 - | Gasket |
| q | Replace. |
| 12 - | Oil pump: |
| q | Always replace completely |
| q | When fitting, remember the crankshaft traction element → Item |
| q | Must sit on dowel sleeves |
| q | removing and installing → Chapter |
| 13 - | Seal |
| q | Renew → Chapter |
| 14 - | Coupling |
| q | Oil well before fitting the oil pump |
