SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4 cylinder Fuel-injection engine (1.4l, 4 valves) | Enginecrankshaft group, pistons | Engine block, flanges | Crankshaft sealing flange, on the flywheel side: Replace ( Assembly tool T10134 ) | D - Mount the sender wheel with the assembly tool T10134 to the crankshaft flange

D - Mount the sender wheel with the assembly toolT10134 to the crankshaft flange

D - Mount the sender wheel with the assembly tool -T10134- to the crankshaft flange

–	Tighten the hexagonal nut of the assembly device -T10134- to a torque of 35 Nm using the torque wrench -V.A.G 1331- and the insertable terminal e/c 24 -V.A.G 1332/11-.

Note

A small air gap must be present between cylinder block and sealing flange after tightening hexagon nut to 35 Nm.