seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Renewing crankshaft oil seal - pulley end > < Removing and installing engine speed senderG28

Leon Mk2

Removing and installing flywheel
Removing and installing flywheel
t  removing → Anchor
t  installing → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Hose clamp -3067-, see equivalent → Anchor
  W00-0026
removing
l  Gearbox removed.
–  Remove the lock plate of the clutch → Rep. gr.30.
–  Insert counterhold tool -3067- to slacken bolts.
–  Remove bolts and take off flywheel.
installing
Installation is carried out in the reverse order; note the following:
–  Tightening torques → Chapter.
  Note
t  Replace the bolts tightened using goniometrics.
t  Installation is only possible at one position through the off-set arrangement of the boreholes.
–  Move counter-hold -3067- to tighten the bolts.
–  Install the lock plate of the clutch → Rep. gr.30.
  A13-10520

Renewing crankshaft oil seal - pulley end > < Removing and installing engine speed senderG28