SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
High-pressure pump - exploded view >
< Cleaning throttle valve moduleJ338
Leon Mk2
Power unit
4 cylinder Injection engine (1.2 l direct injection engine, turbocharger)
Mixture preparation system, electronic inj.,Gas / Injection system
Intake manifold: removing and installing
Intake manifold: removing and installing
Intake manifold: removing and installing
t
Removing
→ Anchor
t
Installing
→ Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda
→ Chapter
.
Special tools and workshop equipment required
t
Base -VAS 6340-, see equivalent
→ Anchor
t
Torque wrench -VAG 1331-, see equivalent
→ Anchor
.
Removing
–
Drain coolant
→ Chapter
.
–
Remove the throttle control unit
→ Chapter
.
–
Disconnect the coolant pipe
-3-
and remove the connectors
-1-
.
–
Unscrew the securing bolts ignition transformer -N152-
-2-
and move the ignition transformer to one side.
–
Unscrew the fastening bolts of the intake manifold beneath the fuel rail
-arrow-
.
Installing
Installation is carried out in the reverse sequence; note the following:
Tightening torque of intake manifold fixing screws: 20 Nm
Power unit
4 cylinder Injection engine (1.2 l direct injection engine, turbocharger)
Mixture preparation system, electronic inj.,Gas / Injection system
Intake manifold: removing and installing
High-pressure pump - exploded view >
< Cleaning throttle valve moduleJ338