SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4 cylinder Injection engine (1.4 litre direct injection engine, turbocharger and chain control) | Enginecrankshaft group, pistons | Removing and installing sealing flanges and flywheel or drive plate | Renewing crankshaft sealing flange - flywheel end | D - Pressing sender wheel onto crankshaft flange using assembly toolT10134

D - Pressing sender wheel onto crankshaft flange using assembly toolT10134

D - Pressing sender wheel onto crankshaft flange using assembly tool -T10134-

–	Tighten hexagon nut of assembly tool -T10134- to 35 Nm using torque wrench -V.A.G 1331- and tool insert 24 mm -V.A.G 1332/11-.

Note

A small air gap must be present between cylinder block and sealing flange after tightening hexagon nut to 35 Nm.