Leon Mk2
| Exhaust manifold and front exhaust pipe with catalytic converter - Assembly overview |
| 1 - | Exhaust manifold |
| q | Removal and installation |
| 2 - | Retaining bracket |
| 3 - | Heat shield |
| 4 - | Lambda probe -G39- (before catalytic converter) - 55 Nm |
| q | When replacing, delete the learnt values in the engine controller → vehicle diagnosis device, „Guided function“. |
| q | When reusing, only grease the thread with hot bolt paste -G 052 112 A3-; the paste must not get into the slots on the sender body |
| 5 - | 10 Nm |
| 6 - | 25 Nm |
| q | Renew |
| 7 - | Seal |
| q | Renew |
| 8 - | Lambda probe after catalytic converter -G130- - 55 Nm |
| q | When replacing, delete the learnt values in the engine controller → vehicle diagnosis device, „Guided function“. |
| q | When reusing, only grease the thread with hot bolt paste -G 052 112 A3-; the paste must not get into the slots on the sender body |
| q | The plug connection is located beneath the right underbody trim of the vehicle. |
| 9 - | Double clamp, front |
| q | Align exhaust system so it is free of stress before tightening clamp → Chapter |
| q | Installation position → Fig. |
| q | Tighten bolted connections evenly. |
| 10 - | 25 Nm |
| 11 - | Primary exhaust pipe |
| q | With catalytic converter |
| q | Protect from damage by knocks and impact |
| q | With vibration damper |
| q | Do not bend decoupling element more than 10°. It may be damaged |
| q | Removing and fitting → Chapter |
| q | Align exhaust system so it is free of stress → Chapter |
| 12 - | Mounting |
| q | Replace if damaged |
| 13 - | 23 Nm |
| 14 - | 25 Nm |
| q | Renew |
| q | Coat threaded studs of the exhaust manifold with hot bolt paste -G 052 112 A3- |
| 15 - | 25 Nm |
| 16 - | Support for front exhaust manifold |
|
|
