SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4 cylinder injection engine (1.6 l engine, roller rocker arms) | Exhaust system | Exhaust system (Engine codes BGU, BSE, BSF, CCSA)

Centre and secondary silencers: Separate

t	In order to replace the centre and rear silencers separately, the connecting pipe can be cut at the marked point.

t	The cutting point is marked with an indentation on the outside of the exhaust pipe.

Special tools and workshop equipment required

t	Pliers -U-40075-

t	Protective glasses

Operation process

WARNING

Wear goggles.

–	Cut through exhaust pipe at right angles -arrow 2- using pliers -U-40075- .

–	Position the double clamp -4- at side markings -arrow 1- and -arrow 3-.

–	Install double clamp so that the bolt end does not project over the clamp lower edge.

l	Bolted connection faces to rear.

–	Align exhaust system without tension → Chapter

SEAT Workshop Service and Repair Manuals