SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4 cylinder Injection engine (2.0l, 4V Direct injection, turbocharger and chain control) | Engine assy,cylinder block,crankcase | Assembly mountings | Checking adjustment of assembly mountings (engine/gearbox mountings)

Checking adjustment of assembly mountings (engine/gearbox mountings)

There must be a distance -a- of at least 10 mm between the engine support foot and the right-hand side longitudinal member.

The moulded edge on the engine support -2- must be parallel to the support arm -1-.

–	If the conditions are not met, the assembly mountings must be adjusted → Chapter.

SEAT Workshop Service and Repair Manuals