seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing sealing flange (gearbox end) > < Assembly overview - sealing flange on gearbox side and flywheel

Leon Mk2

Removing and installing flywheel
Removing and installing flywheel
Special tools and workshop equipment required
   
t  Counterhold tool -3067-
Removing:
–  Remove gearbox → Transmission; Rep. gr.37
  Caution
To prevent damage to the dual-mass flywheel when removing, the bolts -B- must not be removed with an impact wrench or similar. The bolts are only be unscrewed by hand.
  W00-0026
–  Rotate the dual-mass flywheel -A- so that the bolts -B- align centrally with the holes -arrows-.
–  When removing bolts -B-, make sure that bolt heads do not »jam« on flywheel.
  A30-0102
–  Insert counterhold -3067- in hole -B- of cylinder block.
–  Unbolt dual-mass flywheel.
Installing:
Installation is carried out in the reverse order; note the following:
l  Tightening torque → Item
–  Use new securing bolts.
  A13-0051
–  Insert counterhold -3067- in hole -A- of cylinder block.
  A13-0051

Removing and installing sealing flange (gearbox end) > < Assembly overview - sealing flange on gearbox side and flywheel