Leon Mk2
Catalytic converter and attaching parts - Assembly overview |
1 - | Seal |
q | replace |
2 - | Lambda probe -G39- |
q | Cylinder bank 1, probe 1 |
q | 55 Nm |
q | The thread on new Lambda probes is coated with high-temperature paste |
q | If re-using the Lambda probe, coat only the thread with high temperature paste; the paste must not get into the slots of the probe body |
q | Hot bolt paste -G 052 112 A3- |
3 - | Front exhaust pipe with catalytic converters |
Caution
|
q | Protect catalytic converter from damage by knocks and impact |
q | Removing and installing → Chapter. |
q | Align exhaust system so it is free of stress → Chapter. |
4 - | Suspension |
q | If this is damaged, replace it |
5 - | Lambda probes after the catalytic converter -G130- |
q | Cylinder bank 1, probe 2 |
q | 55 Nm |
q | The thread on new Lambda probes is coated with high-temperature paste |
q | If re-using the Lambda probe, coat only the thread with high temperature paste; the paste must not get into the slots of the probe body |
q | Hot bolt paste -G 052 112 A3- |
6 - | 25 Nm |
7 - | Securing bolt |
q | 25 Nm |
8 - | Seal |
q | replace |
9 - | 40 Nm |
q | replace |
q | Lubricate studs of exhaust manifold with high-temperature lubricant. |
q | Hot bolt paste -G 052 112 A3- |