Leon Mk2
Part I oil pump |
1 - | 15 Nm |
2 - | Retainer |
q | Wiring harness for the oil level and oil temperature sender -G266- |
3 - | Dip stick |
q | The oil level should not be over the MAX mark! |
q | Marks → Fig. |
4 - | Filling funnel |
5 - | Guide pipe |
6 - | Dowel sleeves |
7 - | O ring |
q | Renew |
8 - | 15 Nm |
9 - | Oil suction pipe |
q | Clean strainer if dirty |
10 - | Oil deflector |
11 - | 15 Nm |
12 - | 15 Nm |
13 - | Oil pan |
q | Clean sealing surface before installing |
q | Install with silicone sealant -D 176 404 A2- → Chapter. |
14 - | Seal |
q | Rolled onto the oil drain plug |
15 - | Oil drain plug, 30 Nm |
q | Screw with seal that cannot be lost |
16 - | 10 Nm |
17 - | Oil level/oil temperature sender -G266- |
q | Check → Vehicle diagnostic, testing and information system VAS 5051„function and component selection mode“ |
18 - | Seal |
q | Renew |
19 - | Oil pump: |
q | With pressure relief valve 12 bar |
q | Before installing, check that the two dowel sleeves for centering oil pump/cylinder block are fitted. |
q | Replace if there is scoring on the friction surfaces or the gear teeth. |
q | Removing and installing → Chapter |
20 - | Pinions |
21 - | 20 Nm + 90° |
q | Renew |
22 - | Chain for oil pump |
23 - | Sealing flange |
q | Removing and installing → Chapter |
q | Install with silicone sealant -D 176 404 A2-. |
q | Replace crankshaft oil seal - pulley side. → Chapter |
24 - | Chain tension device with tensor rail, 15 Nm |
q | Pre-tension spring and engage before installing |