Leon Mk2
| Exhaust system - exploded view |
| 1 - | Rear tube bridge |
| 2 - | Middle silencer |
| q | In original factory equipment, this is a single piece with the rear silencer. In case of repair, replace separately |
| q | Separating exhaust system → Chapter |
| q | Fit and align exhaust system free of stress → Chapter. |
| 3 - | Suspension |
| 4 - | Lambda probe after catalytic converter -G130- 55 Nm |
| q | When reusing, only grease the thread with hot bolt paste -G 052 112 A3-; the paste must not get into the slots on the sender body |
| q | The plug connection is located beneath the right underbody trim. |
| 5 - | 23 Nm |
| 6 - | Suspension |
| q | Replace in case of damages |
| 7 - | Primary exhaust pipe |
| q | With catalytic converter |
| q | Protect from damage by knocks and impact |
| q | With flexible joint |
| q | Do not bend flexible joint more than 10°. It may be damaged |
| q | Removing and installing → Chapter |
| q | Fit and align exhaust system free of stress → Chapter. |
| 8 - | 25 Nm |
| q | Renew |
| q | Coat threaded studs of the exhaust manifold with hot bolt paste -G 052 112 A3- |
| q | Observe the correct tightening order |
| 9 - | Seal |
| q | Renew |
| 10 - | Exhaust manifold |
| q | Removing and installing → Chapter |
| 11 - | 25 Nm |
| q | Renew |
| 12 - | Lambda probe -G39- (before catalytic converter) - 55 Nm |
| q | When reusing, only grease the thread with hot bolt paste -G 052 112 A3-; the paste must not get into the slots on the sender body |
| 13 - | Clamp (front) |
| q | Align exhaust system so it is free of stress before tightening clamp → Chapter |
| q | Installation position → Fig. |
| q | Tighten bolted connections evenly. |
| 14 - | 25 Nm |
| 15 - | Front tube bridge |
| 16 - | 23 Nm |
| 17 - | 23 Nm |
| 18 - | Holder |
| q | Replace in case of damages |
| 19 - | Clamp (rear) |
| q | For separate replacement of centre and rear silencers |
| q | Installation position → Fig. |
| q | Tighten bolted connections evenly. |
| 20 - | 25 Nm |
| 21 - | Holder |
| q | Replace in case of damages |
| 22 - | Secondary silencer |
| q | In original factory equipment, this is a single piece with the centre silencer. In case of repair, replace separately |
| q | Fit and align exhaust system free of stress → Chapter. |
| q | Separating exhaust system → Chapter |
| 23 - | Suspension |
| q | Replace in case of damages |
| 24 - | 23 Nm |
| 25 - | 23 Nm |
|
|
|
|
