Leon Mk2
| Part III |
| 1 - | Toothed belt guard - lower part |
| 2 - | Toothed belt guard - centre section |
| 3 - | 10 Nm |
| 4 - | Console |
| 5 - | 45 Nm |
| 6 - | Toothed belt guard - upper part |
| 7 - | Notched belt |
| q | Before removing this, mark the rotation direction |
| q | Check for wear |
| q | Do not bend |
| q | Removing and fitting, tightening → Chapter |
| 8 - | 25 Nm |
| 9 - | Washer |
| 10 - | 100 Nm |
| q | Use tool -T20018A- to loosen and tighten |
| 11 - | Cogwheel for camshaft |
| q | Note the fitted position: The narrow core of the camshaft cogwheel should face outwards and the TDC mark should be visible |
| 12 - | Camshaft cogwheel protection |
| 13 - | 10 Nm |
| 14 - | Pin |
| q | Ensure correct seating |
| 15 - | Hall sender -G40- |
| q | Ensure the correct seating of the base plate when tightening the bolts |
| 16 - | 10 Nm |
| 17 - | Toothed belt guard - rear |
| 18 - | 20 Nm |
| 19 - | Semi-automatic tension roller |
| q | Installation position → Fig. |
| q | Checking → Chapter |
| 20 - | Coolant pump |
| q | Ensure that smooth rotation without problems |
| q | In case of a fault or incorrect seal: replace completely |
| q | Removing and fitting → Chapter |
| 21 - | 15 Nm |
| 22 - | Timing belt cogwheel, crankshaft |
| q | There must be no oil on the contact surface between the toothed belt and the crankshaft |
| 23 - | 90 Nm + 1/4 turn (90°) |
| q | Replacement |
| q | Use tool -T20018A- to loosen and tighten |
| q | Threads and shoulder must be free of oil and grease |
|
|
