Removing and installing parts of cooling system |
WARNING Hot vapour/hot coolant may escape when opening expansion tank. Cover cap with cloth and open carefully. |
|
Note t
| When the engine is hot the cooling system is under pressure. If necessary, release pressure before beginning repair work. |
t
| For fitting spring-type clips, it is advisable to use counterhold -T20174- or pliers -T20029-. |
t
| Renew gaskets and seals. |
t
| The arrow markings on the coolant pipes and on the ends of the hoses must be aligned with each other. |
t
| Engine cooling system, engine side - Components overview → Chapter |
t
| Bodywork cooling system, - Components overview → Chapter |
t
| Draining and filling cooling system → Chapter |
t
| Removing and installing coolant pump → Chapter. |
t
| Coolant distributor box with Cooling system thermostat managed on the basis of a map of characteristics -F265- - Components overview → Chapter |
t
| Removing and installing thermostat → Chapter. |
t
| Check the Map-controlled engine cooling thermostat -F265- → Chapter |
t
| Coolant pipe, removing and installing → Chapter |
t
| Removing and installing radiator fan -V7- and radiator fan 2 -V177- → Chapter |
t
| Engine cooling system: checking for leaks → Chapter |
|
|
|