Leon Mk2
| Exhaust system: Component overview, vehicles with engine code BMN |
| 1 - | Vehicle floor rear cross member |
| 2 - | Middle silencer |
| q | In relation to the version |
| q | In case of repairs, replace the factory fitted end silencer as one part |
| q | Cutting point → Chapter |
| q | Align exhaust system without tension → Chapter |
| 3 - | Suspension |
| q | If this is damaged, replace it |
| 4 - | Mounting |
| q | If this is damaged, replace it |
| 5 - | 23 Nm |
| 6 - | Retainer |
| q | If this is damaged, replace it |
| 7 - | 23 Nm |
| 8 - | 23 Nm |
| 9 - | Retainer |
| q | For particle filter |
| 10 - | 23 Nm |
| 11 - | Securing clip - 7 Nm |
| q | Replace. |
| 12 - | Seal |
| q | Replace. |
| 13 - | Particle filter with main catalytic converter |
| q | Removing and fitting → Chapter |
| q | Following replacement of the particle filter, the “guided functions” → Vehicle diagnosis, testing and information system VAS 5051 must be adapted. |
| 14 - | Front clamp |
| q | Align exhaust system so it is free of stress before tightening clamp → Chapter |
| q | Installation position → Fig. |
| q | Tighten bolted connections evenly. |
| 15 - | 23 Nm |
| 16 - | Vehicle floor front cross member |
| 17 - | 23 Nm |
| 18 - | 23 Nm |
| 19 - | Suspension |
| q | If this is damaged, replace it |
| 20 - | Rear clamp |
| q | To replace centre and front silencers separately |
| q | Installation position → Fig. |
| q | Tighten bolted connections evenly. |
| 21 - | 23 Nm |
| 22 - | Suspension |
| q | If this is damaged, replace it |
| 23 - | Secondary silencer |
| q | In the original factory equipment, this is a single piece with the centre silencer. In case of repair, replace separately |
| q | Cutting point → Chapter |
| q | Align exhaust system without tension → Chapter |
| 24 - | Mounting |
| q | If this is damaged, replace it |
| 25 - | 23 Nm |
| 26 - | 23 Nm |
