seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Vehicles with air conditioning > < Oil pump removal and installation

Leon Mk2

Removal
Removal
–  Remove main drive toothed belt → Chapter; Removing, installing and tensioning toothed belt.
   
–  Secure crankshaft toothed belt -1- to crankshaft with old securing bolt -2-.
–  Position crankshaft at TDC cylinder: 1:
The tooth ground down on the toothed belt sprocket must align with mark on the oil pump -arrow-.
  Note!
Do not mix up marks on oil pump. The tooth ground down must coincude with the mark “4V (4 valves)”.
  N17-0076
–  Turn crankshaft/toothed belt sprocket three teeth anti-clockwise away from TDC:
The third tooth -arrow- to the right of the tooth ground down -A- on the toothed belt sprocket must align with TDC mark on the oil pump housing.
  Note!
This procedure moves the crankshaft to the correct installation position for the oil pump. One of the polygon cams on the crankshaft is uppermost.
–  Remove main drive tensioning roller.
–  Remove sump → Chapter.
–  Remove suction pipe → Item.
–  Remove crankshaft toothed belt sprocket.
  N17-0073

Vehicles with air conditioning > < Oil pump removal and installation