WARNING | The fuel system is under pressure. Before opening the system place a cloth around the connection. Then release pressure by carefully loosening the connection. |
|
| To prevent injuries to persons and/or damage to the injection and ignition system, the following must be observed: |
| t
| Do not touch or disconnect ignition wiring when the engine is running or being turned at starter speed. |
| t
| The ignition must be switched off before connecting or disconnecting injection or ignition system wiring or tester cables. |
| t
| In order to rotate the engine in starter mode without actually starting it, for example: compression testing, the Hall sender (ignition distribution) must be disconnected. |
| Observe the following if test and measuring instruments are required during a test drive: |
| t
| Any test and measurement equipment to be used must be installed on the rear seat to be used by a second mechanic. |
| If this equipment is used in the front passenger seat, the operator could be injured by the triggering of the airbag in the case of an accident. |
|
|
|
