| –
| Fit the new control unit in the mount frame and fix the brace in the initial position. |
| –
| Plug in the control unit connector and secure it. |
| –
| Check the previous code and encode the new control unit → Chapter. |
| –
| Adapt the new control unit to the throttle valve drive unit → Chapter. |
| –
| Adapt the new control unit to the electronic immobiliser → Chapter. |
| –
| Finally, consult the fault memory of the new engine control unit and, if necessary, clear the fault memory → Chapter, Fault memory: consulting and clearing. |
|
|
|
