seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
ESP sensor unitG419 :removing and installing > < Brake light switchF: prior to week 45/05: removing and installing

Leon Mk2

Brake pedal position senderG100: after 45/05: removing and fitting
Brake pedal position sender -G100-: after 45/05: removing and fitting
In vehicles manufactured prior to week 45/05, the brake light switch is located on the brake pedal.
Removing
–  Remove engine cover
–  In some vehicles it is necessary to remove the intake hose.
   
–  Disconnect the connector -1- of the brake pedal position sender -G100-.
–  Loosen the bolt -2- of the brake pump.
–  Remove the brake pedal position sender -G100--3- under the brake pump and remove it upwards from the support flange -4-.
Installing
–  Install in reverse order.
  N47-10071
Specified torque: 
Torx bolt to the brake pump5 Nm

   

ESP sensor unitG419 :removing and installing > < Brake light switchF: prior to week 45/05: removing and installing