Leon Mk2
ABS TRW (ABS/EDL/TCS/ESP) |
1 - | ABS control unit -J104- |
q | Installation location: on the hydraulic unit, on left in engine compartment, under battery. |
q | Do not separate connector before successfully completing self-diagnosis. Switch ignition off before separating connector. |
q | Must not be separated from ABS hydraulic unit -N55- |
q | removing and fitting → Chapter |
2 - | ABS hydraulic unit -N55- |
q | Installation location: In engine compartment, on the left hand side below battery |
The hydraulic unit consists of the components: |
q | Brake pressure sensor -G201- |
q | ABS hydraulic pump -V64- |
q | Valve block (contains inlet and outlet valves). |
q | ABS hydraulic pump -V64- and valve block must not be separated from one another. |
q | Must not be separated from ABS control unit -J104- |
q | removing and fitting → Chapter |
3 - | Brake pad warning lamp -K32- |
q | Installation location: On the instrument panel |
4 - | ABS warning lamp -K47- |
q | Installation location: On the instrument panel |
5 - | ESP and TCS warning lamp -K155- |
q | Installation location: On the instrument panel |
6 - | Brake system warning lamp -K118- |
q | Installation location: On the instrument panel |
7 - | Brake light switch -F- |
q | Installation location: On brake master cylinder |
q | removing and fitting → Chapter |
8 - | TCS and ESP button -E256- |
q | Installation location: In centre console |
9 - | ESP sensor unit -G419- and control unit for electromechanical parking brake -J540- |
q | Installation location: Under the centre console |
q | Combined lateral acceleration sender -G200-, yaw rate sender -G202- and longitudinal acceleration sender -G251-. |
q | Installed in one housing together with control unit for electromechanical parking brake -J540- |
q | removing and fitting → Chapter |
10 - | Diagnostics connection |
q | Installation location: driver side foot well area cover |
11 - | Steering angle sender -G85- |
q | Installation location: at the steering column between the steering wheel and the steering column switch. |
q | removing and fitting → Chapter |
12 - | Wheel bearing housing |
13 - | Front right/left speed sensor -G45-/-G47- |
q | removing and fitting → Chapter |
14 - | Wheel hub with wheel bearing |
q | The ABS sensor ring is installed in the wheel bearing |
15 - | Wheel bearing housing |
16 - | Rear right/left speed sensor -G44-/-G46- |
q | Removing and installing (front-wheel drive) → Chapter |
17 - | Wheel hub with wheel bearing |
q | The ABS sensor ring is installed in the wheel bearing |