seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Notes for repair work on anti-lock brake system > < Installation location overview|ABS
ABS/ESP
   
ABS/ESP
1 - ABS control unit -J104-
q   Installation location: on hydraulic unit, on left in engine compartment, under battery tray.
q   Do not separate connector before successfully completing self-diagnosis. Switch ignition off before separating connector.
The following components are integrated into the control unit:
t  Lateral acceleration sender -G200-
t  Sender for rotational speed -G202-
t  Longitudinal acceleration sender -G251- (depending on equipment fitted)
q   removing and installing → Chapter
2 - ABS hydraulic unit -N55-
The hydraulic unit consists of the components:
q   ABS return flow pump -V39-
q   Brake pressure sender -G201-
q   Valve block (contains inlet and outlet valves).
q   ABS return flow pump -V39- and valve block should not be separated from each other
q   removing and installing → Chapter
3 - ESP and TCS warning lamp -K155-
q   Installation location: On the instrument panel
4 - ABS warning lamp -K47-
q   Installation location: On the instrument panel
5 - Brake system warning lamp -K118-
q   Installation location: On the instrument panel
6 - Parking brake warning lamp -K139-
q   Installation location: On the instrument panel
7 - Brake light switch -F-
q   Including brake pedal switch -F47-.
q   removing and installing → Chapter
8 - TCS and ESP button -E256-
q   Installation location: In centre console
9 - Diagnostics connection
q   Installation location: driver footwell cover
10 - Steering angle sender -G85-
q   Installation location: at the steering column between the steering wheel and the steering column switch.
q   Observe installation instructions.
→ Chapter
11 - Front right/left speed sensor -G45-/-G47-
q   removing and installing → Chapter
12 - Wheel hub with wheel bearing
q   ABS sensor ring is installed in wheel bearing.
13 - Rear right/left speed sensor -G44-/-G46-
q   Removing and installing (drum brakes) → Chapter
14 - Wheel hub with wheel bearing
q   ABS sensor ring is installed in wheel bearing.

   

Notes for repair work on anti-lock brake system > < Installation location overview|ABS