seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Rear axle sensor ring: checking, removing and fitting (disk brakes and drum brakes) > < Parts of the ABS system on the rear axle: remove and install (vehicles with disc brakes)

Leon Mk2

Rear axle revolution sensor: removing and fitting (disk brakes)
Rear axle revolution sensor: removing and fitting (disk brakes)
Removal:
–  Raise the vehicle.
   
–  Disconnect connector -1- for revolution sensor.
–  Remove Allen bolt -2- from the axle stub.
–  Remove ABS rev. sensor from the axle stub and from the support plate.
Fitting
–  Before fitting the revolution sensor the inside surface of the opening must be cleaned and the sensor must be lubricated completely with →  Parts catalogue.
–  Fit the revolution sensor into the axle stub orifice and tighten to tightening torque 8Nm.
–  Connect cable connector -1- to the revolution sensor.
  N45-0118

Rear axle sensor ring: checking, removing and fitting (disk brakes and drum brakes) > < Parts of the ABS system on the rear axle: remove and install (vehicles with disc brakes)