Leon Mk2
Parts of the ABS system on the rear axle: remove and install (vehicles with drum brakes) |
1 - | Axle body |
2 - | Hexagon socket head bolt |
q | 8 Nm |
3 - | ABS rev. sensor |
q | Verified by self-diagnosis |
q | Before fitting the sensor, clean the inner surface of the hole and apply solid lubricant paste → Parts catalogue. |
q | Removal and fitting, vehicles with drum brakes → Chapter |
4 - | Brake line |
5 - | Axle connection |
6 - | Hand brake cable |
7 - | Bolt and washer |
q | 30 Nm + 90° |
8 - | Cross-head bolt |
q | 4 Nm |
9 - | Brake drum |
q | Brake drum diameter: 200 mm |
q | Wear limit 201 mm |
q | Retract brake before removing brake drum → Chapter |
q | Clean thoroughly and check for damage, wear, correctness of dimensions, wheel bolt threads for damage, and if the surface of the brake is in good condition |
10 - | Plug. |
q | Removal and installation of vehicles with drum brakes → Running gear, axles, steering; Rep. Gr. 42 |
11 - | Twelve-sided, self-locking nut |
q | 70 Nm + 30° |
q | Replace after each removal |
12 - | Wheel housing with wheel bearing and sensor ring |
q | Sensor ring integrated into bearing oil seal |
q | Always replace entire unit |
q | Removal and installation of vehicles with drum brakes → Running gear, axles, steering; Rep. Gr. 42 |
13 - | Brake carrier with brake pads |