seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Brake pads: removing and fitting - Brembo front wheel brake > < Removal:

Leon Mk2

Fitting
Fitting
  Note
Before fitting the new brake pads, press the cylinder of the brake callipers. Before pressing the piston back, draw off brake fluid from the reservoir with a bleeder bottle. Otherwise, -if brake fluid has been replaced- it might leak and cause damage.
   
–  Retract the brake calliper cylinder using the tool -T20168 -. Ensure that the protection hoods for the cylinders are not damaged.
–  Carefully fit the brake pads.
  E46-0048
–  Fit the pad support spring and insert the support pins in the direction of the -arrow A- on to the brake callipers. When doing this, press the pad support spring -arrow B- down a little until the notch of the support pin protrudes over the edge of the spring.
  E46-0049
–  If necessary, press the cable of the brake pad wear indicator -3- into the groove on the brake calliper.
–  Extract the protection hood -2- and fit the cable -3- in the tab of the hood. Next, reinsert the protection hood onto the breather valve.
–  Fit the brake pad wear indicator connector-1- in the telescopic arm.
  E46-0046

Brake pads: removing and fitting - Brembo front wheel brake > < Removal: